OKI 1.2 Manuel d'utilisateur télécharger pdf (Page 25)

Setup

The VoIP-TA is set up by using the Maintenance Console Software. The

Maintenance Console Software, installed in a PC, is used to communicate

with the VoIP-TA in remote mode via a LAN interface or in local mode via

a RS232C interface. When connecting to the VoIP-TA using the remote

mode via a LAN interface, all network settings such as the assignment of

IP addresses must be already completed.

Maintenance Console Software Requirements

Description Quantity

Maintenance Console Software setup disk (CD-ROM). 1

A PC for installing the Maintenance Console Software.

• An operating system, such as Windows

98, Windows

95, or

Windows NT

4.0, must already be installed in the PC.*

• The PC must be equipped with a S-VGA (Super Video Graphics Array). 1

A LAN cable (UTP, category 3 or 5) or a RS232C cable. 1

Windows

and Windows NT

are registered trademarks of Microsoft

Corporation in the U.S.A. and other countries.

Installing the Maintenance Console Software

Before installing the Maintenance Console Software in a PC, be sure to

close and quit all software and programs running on the PC.

• Insert the CD-ROM into the PC’s CD-ROM drive and execute the Setup

file located on the disk (when reinstalling the software, be sure to

uninstall the previously installed Maintenance Console Software first).

• Follow the prompts appearing on the screen and restart the PC when

the installation has been completed. You may now use the

Maintenance Console Software.

Maintenance Console Software Compatibility

The compatibility relationship between the VoIP-TA unit software and

Maintenance Console Software versions is described in the table below.

*Note

VoIP-TA unit Operation software Maintenance Console Software version

V1.1 02.** V1.0

V1.2 04.00 V1.2

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Pas de commentaire

OKI 1.2 Manuel d'utilisateur Page 25