Oki 520 Manuel d'utilisateur télécharger pdf (Page 18)

Getting Started E-11

4. Adjust the paper feed guides ( ) for the width of the

paper and drop a sheet of paper into the separator.

The paper will automatically feed into the printer, and

the printhead will move back and forth, gently firing

the pins to sense the paper thickness and set the

printhead gap.

If the paper doesn’t feed in properly, the “15” light

on the control panel will begin flashing. To correct

this, press the SHIFT and RESET buttons simulta-

neously, then reload the sheet.

5. Check the baseline for the Top of Form (TOF), indi-

cated by the red line on the clear plastic paper shield

( ).

If it’s OK, press the SEL button and you’re ready to

start printing. If it needs adjustment, set the Top of

Form following the instructions on the next page.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Pas de commentaire

Oki 520 Manuel d'utilisateur Page 18