Oki 520 Manuel d'utilisateur télécharger pdf (Page 16)

Getting Started E-9

7. Adjust the right tractor so that the paper holes are

centered on the pins (careful—if paper is stretched too

tight or left too loose, it can jam and cause problems),

then lock the right tractor in place by pushing back on

the lock lever ( ).

8. Close the paper separator and flip the wire feed guide

over onto the pull-up roller assembly.

The wire feed guide keeps paper from curling back

into the printer.

9. Push the FF/LOAD button. The paper will automati-

cally feed into the printer and the ALARM light will go

out. The printhead moves back and forth, gently firing

the pins to sense the paper thickness and set the

printhead gap.

10. Check the baseline for the Top of Form (TOF),

indicated by the red line on the clear plastic paper

shield ( ). If it’s OK, press the SEL button and

you’re ready to start printing. If it needs adjustment,

set the Top of Form.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Pas de commentaire

Oki 520 Manuel d'utilisateur Page 16