Oki B6200 Series Manuel d'utilisateur télécharger pdf (Page 21)

INSTALLATION AND RELOCATION PROCEDURE > 21

INSTALLING THE DUPLEX UNIT

You can install a duplex unit option on this printer. If a face up tray has

been fitted, remove it by reversing the steps in “Installing the Face Up

(Rear) Tray” on page 14 before installing the duplex unit and refit it when

the duplex unit has been installed.

1. Remove the duplex unit cover by pushing the two tabs as shown

in the diagram (1).

Next, remove the connector cap at the top right of the back of the

printer (2).

2. Insert the right and left tabs at the bottom of the duplex unit into

the holes at the back of the printer, and then align the top part of

the duplex unit with the printer.

Ensure that the connector of the duplex unit is connected to the

connector of the printer.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 65 66

Pas de commentaire

Oki B6200 Series Manuel d'utilisateur Page 21